Casa performance engine bar
 
Use of large mounts is necessary
 
Models: Lambretta S1, Lambretta S2, Lambretta TV2, Lambretta S3, Lambretta Special, Lambretta SX, Lambretta TV3, Lambretta GP, Lambretta Serveta
 
Special high-precision FLAT SIDED main engine bolt set + pair of CP off-set cones + 2 washers + nylok nut set.

The  upgraded, best-selling fixed head engine bolt & offset cones kit. Offset cones are a necessity for most cases where a reedvalve kit is fitted to large frame Lambretta and the actual inlet manifold is so close to the main frame tube that it can actually touch during return suspension travel. The best case scenario is that this will cause untold vibration and make riding a misery and the worst case is that the manifold can break, with dire consequences. To get around this problem, offset frame cones are used to effectively lower the engine as the position of the holes where the engine bolt passes through are eccentrically drilled, thus moving the engine (and inlet manifold) away from the central frame tube. 
Unlike most offset cones on the market, the Casa Performance cones are the wider type needed for use with Series 3 type engine mounts and the main engine bolt is not just a simple piece of bar with threaded ends: it’s also precision-machined along its entire length to avoid movement inside the actual engine mounts. To top this show off, one side also  has a fixed nut head, so the engine bolt cannot spin when being tightened - thus risking to also spin the offset cones around in their seat, leaving your engine out of line with the frame. The only possible fly in the proverbial ointment could have been if the offset cone(s) moved when the scooter was in use, again moving your engine out of alignment.

There is now a flat surface along the engine bolt and the 2 cones have been machined accordingly. This now means that there is absolutely no way the offset cones can move, even minimally, either during tightening of the engine bolt or when the scooter is in use. These new cones are also slotted on one side.

So how do they work? Steve Diffey of Lambretta Obsessions in Australia recently posted this ansewer to that very question, "The bore of each cone has a flat side, it is not simply round. The length of the long engine bar has a corresponding flat, this locates in the cones. Then by assembling the cones and bar loosely into the engine/frame, you can slowly and easily rotate the (whole) assembly until maximum clearance (at the inlet manifold) is achieved, knowing all the time that everything is perfectly aligned before finally locking everything up."

The cones must be inserted into the frame with the slot facing directly upwards.

This all adds up to be the best offset cone & engine bolt set available on the market, bar none.